Have a clogged toilet ruining your day? No problem. A beginner in home repair can unclog that toilet and have it flushing properly in just mere minutes without making a huge mess. Here’s the proper way to unclog a toilet with a plunger:
Step 1. Stop The Water Flow ASAP
If you don’t want a messy overflow and sewage backing up, then do this step as soon as possible. Take the tank’s lid off and find the toilet flapper. The flapper is the part in the tank that stops the water from the tank going into the toilet bowl. Take the top off before you hit the flusher. Keep one hand in the flapper just in case the water rises dangerously to the top.
Step 2. Add Dishwashing Detergent and Hot Water
Heat up water and put in a few cups mixed with dishwashing detergent into the toilet bowl before you start the plunging process. Let it sit for around 2 to 3 minutes and hopefully, the blog will have softened or cleared up. This will make the plunging so much easier than it is working with a hard clog.
Step 3. Get The Plunger
Not all plungers are made equal. If you want to get the best and the most efficient plunger, pick the funnel-cup plunger as it has a flange that provides a good seal. You can wear rubber gloves to get a better grip and use it as a protective shield in case things get worse.
Make your rubber pliable by running it under hot water for a few minutes to loosen it up.
Step 4. Do The Plunge
The very first plunge must be a gentle one. The bell will be full of air, and doing a hard plunge will force that air back, escape the seal and blow up the water in the toilet!
When the pocket of air is out, then it’s time to get down and dirty. Focus on pushing the plunger down with force while maintaining the seal between the flange and the toilet’s exit hole. The upward pull is just as important as the downward push.
Work up a good upward and downward motion for a few minutes, then flush the toilet. Keep your hand on the flapper to prevent overflows. Be patient, as it could take several plunging sessions to break up the blockage. The key to an effective plunge is to always have enough water to cover the seal.
Repeat the sequence until the clog has disappeared and your toilet is working again.